 |
 |
 |
|
|
|
[Sponsors] | ||||
November 17, 2017, 15:58
|
Problem with simulation in ESE Diesel
|
#1 |
|
New Member
Krzysztof
Join Date: Jun 2017
Posts: 2
Rep Power: 0  |
Hello
I create simulations for the thesis based in AFL FIRE ESE DIESEL on data from the engine dynamometer. All the initial parameters were introduced with the fuel dose and the injection time. Unfortunately the difference The maximum pressure between my simulation and the actual results is 50 bar. I used the ECFM-3Z, KHRT, Dukowicza evaporation. I do not know what to do to lower this pressure and start conditions or dose can not change. Thank you in advance for your help |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mpi run problem signal 11 (segmentation fault) FGM simulation | Fedindras | CONVERGE | 1 | October 26, 2017 16:05 |
| Problem in initializing transient simulation with a finer mesh | sidd | CFX | 8 | April 29, 2016 02:25 |
| Simulation of high pressure diesel injector - all phases compressible with cavitation | fivos | CFX | 4 | July 30, 2015 06:48 |
| Dynamic mesh simulation (pimpleDyMFoam) problem | sidlof | OpenFOAM Running, Solving & CFD | 6 | April 12, 2013 11:24 |
| simulation problem -- convection BC | pras | FLUENT | 4 | January 30, 2013 10:41 |
Linear Mode
