|
[Sponsors] |
January 11, 2019, 10:52 |
How to show more the one blade in CFX Post
|
#1 |
New Member
Join Date: Nov 2018
Posts: 15
Rep Power: 7 |
Hi everybody, I was trying to plot some contour showing more than then one blade, as in the image attached, but I wasn't successful.
How is it possible to obtain such a contour? |
|
January 11, 2019, 11:19 |
|
#2 |
Senior Member
Join Date: Jun 2009
Posts: 1,804
Rep Power: 32 |
In CFD-Post, double click on the Domain for the blade. Once the panel is open, select the View tab, and you will see the options to replicate the domain
If you are post-processing a transient blade row results file with Fourier data compression, you can use the "Data Instancing" tab to replicate not only graphically, but timewise as well. Hope the above helps, |
|
January 12, 2019, 08:25 |
|
#3 |
New Member
Join Date: Nov 2018
Posts: 15
Rep Power: 7 |
it worked, thanks a lot!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
defining a blade with mesh motion in cfx | nhlstd | CFX | 2 | December 4, 2019 01:17 |
Cfx post | Aye Mya Moh | CFX | 2 | February 19, 2018 04:14 |
Heat Release in CFX Post | kapopadu | CFX | 0 | April 12, 2013 07:33 |
[ICEM] Blade meshing in ICEM CFX | pol84 | ANSYS Meshing & Geometry | 3 | August 5, 2010 17:19 |
CFX Post export problem | jeff_F | CFX | 0 | August 17, 2009 21:25 |