ask for help about CFX mesh -- CFD Online Discussion Forums

May 29, 2006, 03:05	ask for help about CFX mesh	#1
Eric Guest Posts: n/a	Dear Sir, I use CFX-mesh to generate Mesh. But the mesh quality is not good( verified in CFX-Post). Could you give me some advice on how to set paramrters in CFX-mesh? My model: Length of the cylinder is 11.4 mm, diameter is 2.8 mm, at the center of the cylinder is a hole(1.4 mm) as inlet. Two ends of the cylinder is outlet. Please help me.Many thanks. Eric

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] SnappyHexMesh for internal Flow	vishwa	OpenFOAM Meshing & Mesh Conversion	24	June 27, 2016 08:54
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation	tommymoose	ANSYS Meshing & Geometry	48	April 15, 2013 04:24
CFX Mesh Deformation problem	Silmaril	CFX	7	October 19, 2010 10:00
Mesh from ICEM CFD to CFX ! Error ! Why ? Thanks !	Vu Trinh Tuan	CFX	11	March 28, 2005 19:04
importing mesh from ICEM CFD into CFX 5	Jay	CFX	2	November 12, 2002 13:46

All times are GMT -4. The time now is 20:44.