 |
 |
 |
|
|
|
[Sponsors] | ||||
April 15, 2018, 21:37
|
Working with CKWYP routine
|
#1 |
|
New Member
Amir
Join Date: Aug 2017
Posts: 12
Rep Power: 8  |
Hello
i am trying to use a reduced mechanism. I have the routine CKWYP. I copy the routine, which is in fortran, to udf.in. I tried to add the udf.in to the case. It gets me this error: " Expected to read variable: user_spray_main_flag, but found: CKWYP". I do not have any spray simulation in my case. Is this the right way to configure the reduced mechanism ? |
|
|
|
|
|
April 18, 2018, 16:27
|
|
#2 |
|
New Member
Dan Maciejewski
Join Date: Apr 2018
Location: Madison, WI, USA
Posts: 11
Rep Power: 8 |
Since the reduced mechanism is coded in Fortran, we have to take a few steps to make the reduced mechanism work with CONVERGE. Please refer to the UDF Manual for whichever CONVERGE version you are using, available at convergecfd.com downloads page.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Processor 0 not working | vishwesh | OpenFOAM Running, Solving & CFD | 0 | November 17, 2017 03:35 |
| solver is working in windows but not in linux | jbseo | CFX | 0 | August 30, 2016 00:20 |
| [OpenFOAM.com] [v3.0+] not working anymore (note: was missing entry in .bashrc) | Jambne | OpenFOAM Installation | 1 | May 29, 2016 14:37 |
| DPM parallel is not working but serial is working | johnwinter | FLUENT | 1 | March 27, 2012 02:01 |
| Help required on working of Woven | aero | FLUENT | 0 | January 16, 2007 06:25 |
Linear Mode
