CONVERGE

Read this first: How to ask a question on the forums

Page 12 of 24

Threads in Forum : CONVERGE

Rating Thread / Thread Starter	Last Post	Replies	Views
"Numbers dont add up" LauraSumner	February 2, 2021 02:59 by Suresh Nambully	9	1,479
Converge stops simulation, but no .error file Laurens	December 20, 2023 15:52 by bb91936762	3	252
WARNING: the crevice model does not converge, reset crevice pressure! Laurens	December 26, 2023 13:15 by bb91936762	1	240
Second order momentum equation Laurens	March 6, 2024 06:54 by Laurens	1	186
Can CONVERGE handel very low fuel temp in gas turbine learner1111	March 28, 2017 11:16 by Yaju	2	1,025
questions on wall film simulation learner1111	April 24, 2017 11:03 by Yaju	1	923
questions on parallel efficiency learner1111	April 26, 2017 15:27 by MFGT	2	1,058
questions on wall film simulation 2 learner1111	June 5, 2017 13:00 by SamWijey	1	1,153
there are duplicated species in the species list Lehaibmo	May 29, 2019 11:11 by kbansal	1	1,145
Humidity in a turbocharged IC engine LeMans	August 24, 2018 15:13 by LeMans	3	900
Tumble Torque LeMans	August 24, 2018 14:38 by LeMans	2	1,125
Transport Data Missing LeoBlunt	September 20, 2020 01:31 by LeoBlunt	4	875
Kicgen tool not included LeoBlunt	September 29, 2020 12:08 by crajath	3	1,336
Questions about Converge liang11	December 2, 2020 00:43 by liang11	3	1,056
The effect of Maximum Mach CFL on in-cylinder pressure liang11	December 17, 2020 08:09 by MCoil	11	1,202
WARNING：removing a parcel at location () liang11	December 29, 2020 19:35 by liang11	4	860
'Tot_Inj_Mass' decrease liang11	February 4, 2021 16:02 by jetcheve	3	772
Some confusion with CHT lily-spraycombustion	December 21, 2023 03:02 by lily-spraycombustion	4	339
Some questions about using radiation model lily-spraycombustion	January 25, 2024 14:17 by angela.wu	1	223
converge compression ratio liuadam67	July 5, 2017 11:09 by liuadam67	7	1,739
Converge_HPC_Install ljxsbest	February 6, 2024 15:20 by ksrivast	1	182
Problem with the 3D-results Losinyao	June 8, 2023 12:51 by awaikar	1	463
WARNING: [ 531] Found a parcel outside the domain. Losinyao	June 21, 2023 00:33 by alenp07	5	806
JOB ABORT invoked by rank 17 ltl	January 25, 2021 15:05 by nitesh.attal	3	2,822
ERROR: Safe Malloc has detected a null pointer ltl	April 7, 2021 14:00 by jetcheve	5	1,083
species are missing within thermo.dat ltl	August 16, 2023 13:30 by Totoralio	3	945
DWI，spray modeling setup ltl	September 23, 2021 12:08 by asofianopoulos	3	729
Calculation speed ltl	August 1, 2022 17:19 by Xiao Ren	1	521
How to spray gas-fuel in converge luckyboy	March 1, 2017 08:47 by whysoserious	7	2,497
abbreviation of fuel is supported ? luckyboy	September 18, 2017 22:28 by luckyboy	2	750
calculate slowly luckyboy	September 20, 2017 04:57 by luckyboy	5	955
pressure increase sharply luckyboy	September 25, 2017 07:59 by luckyboy	11	965
multi-fuel case can't ignition luckyboy	September 30, 2017 03:33 by MFGT	7	971
Why will hydrogen go out in compression ignition luckyboy	March 19, 2018 13:33 by nitesh.attal	3	1,157
No heat release in a simulation luckyboy	April 30, 2018 14:46 by Dan.Maciejewski	1	1,084
could not find a side polygon that surrounds the negative area side polygon luckyboy	May 16, 2019 22:29 by Jammie Law	7	1,648
mass flow luckyboy	May 14, 2018 21:38 by luckyboy	2	1,079
heat release increase suddenly luckyboy	August 3, 2018 08:42 by MFGT	1	1,016
FFT:Frequency-Amplitude plot luckyboy	May 25, 2019 06:19 by luckyboy	2	1,322
warning:Dij_inv is too small luckyboy	November 2, 2021 10:08 by luckyboy	4	707

Read this first: How to ask a question on the forums

Page 12 of 24

« First

Last »

	New posts		Hot thread with new posts
	No new posts		Hot thread with no new posts
	Thread is closed

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

All times are GMT -4. The time now is 06:46.