|
[Sponsors] |
How ANSYS calculate flow area in 2D simulation |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 29, 2023, 00:32 |
How ANSYS calculate flow area in 2D simulation
|
#1 |
New Member
Join Date: Oct 2023
Posts: 1
Rep Power: 0 |
Hello everyone,
For my bachelor's thesis, I am calculating 2D labyrinth seals that are located at different diameters. As the diameter increases, the ring area or gap area of the seal also increases. What options do I have within the 2D representation in side view to account for the different diameters? Because the clearance, or tolerance of the seal is constant, but the diameter increas. Alternative, know some one how ansys calculate ore know the inlet ore outlet area? I appreciate any assistance. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Two phase flow simulation in axial flow compressor | bassamelsayed | CFX | 3 | January 6, 2023 09:53 |
What are the best settings for a channel flow simulation? | Ashkan Kashani | CFX | 3 | October 13, 2022 21:36 |
Problem in Clod Flow Simulation of IC Engine in ANSYS | Rajat Arya | ANSYS | 0 | August 14, 2018 05:55 |
cavitatingFoam: calculate the mass flow rate in a specific area | sylv20 | OpenFOAM Post-Processing | 4 | September 30, 2015 05:36 |
calculate volume flow from a 2D simulation | SimonH. | OpenFOAM | 0 | October 27, 2009 04:39 |