Problem in IC Engine simulation -- CFD Online Discussion Forums

October 3, 2015, 01:18

Problem in IC Engine simulation

SATIS

New Member

SATISH

Join Date: Oct 2015

Posts: 1

Rep Power: 0

I am trying to simulate port flow in an internal combustion engine. However, the simulation ends just near the inlet valve itself. Hence, i am unable to see the flow patterns in different swirl planes.
Please see the attached screenshots. Thank you.

Attached Images

	ice-velocity-magnitude-on-image4-0050.jpg (50.1 KB, 14 views)
	ice-velocity-magnitude-on-image4-0150.jpg (50.4 KB, 10 views)
	ice-velocity-magnitude-on-image4-0200.jpg (50.3 KB, 8 views)
	ice-velocity-magnitude-on-image4-0300.jpg (50.2 KB, 7 views)
	ice-velocity-magnitude-on-image4-0400.jpg (50.1 KB, 9 views)

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
foam-extend-3.0 engine simulation	Slanth	OpenFOAM	0	June 6, 2014 06:14
Simulation of a regenerator in stirling engine	Walle	FloEFD, FloWorks & FloTHERM	2	September 14, 2013 10:32
simulation problem -- convection BC	pras	FLUENT	4	January 30, 2013 11:41
Engine Simulation in parallel	Peter_600	OpenFOAM	0	July 26, 2012 07:02
Large-scale simulation problem	Purushothama	Main CFD Forum	0	November 7, 2010 21:12

All times are GMT -4. The time now is 23:48.