|
[Sponsors] |
May 26, 2016, 12:17 |
DEM setting up
|
#1 |
New Member
frank tsai
Join Date: May 2016
Posts: 1
Rep Power: 0 |
Hi,
I am using DEM function in ansys 16.2 for my fluidized bed, and I found the DEM would take a lot of Ram space during calculating n. Is it a normal situation, or I miss something important when I set up the model ? PS: It spends 24G Ram during the calculation and it takes more than an hour to finish a iteration. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Setting Initial volume fraction for the DEM particles | anoopjangra | STAR-CCM+ | 4 | March 26, 2024 06:59 |
using chemkin | JMDag2004 | OpenFOAM Pre-Processing | 2 | March 8, 2016 22:38 |
[snappyHexMesh] determining displacement for added points | CFDnewbie147 | OpenFOAM Meshing & Mesh Conversion | 1 | October 22, 2013 09:53 |
Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 21:58 |
Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |