 |
 |
 |
|
|
|
[Sponsors] | ||||
How to pre-Fill a body with water before starting the calculation |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 2, 2017, 05:20
|
How to pre-Fill a body with water before starting the calculation
|
#1 |
|
New Member
Peyman Afshari
Join Date: Nov 2016
Posts: 2
Rep Power: 0  |
Hi, I'm trying to fill a single-phased body with water before starting the calculation using ANSYS FLUENT 18.
is there any way to achieve this setup? |
|
|
|
|
|
September 2, 2017, 08:06
|
|
#2 |
|
Senior Member
Cees Haringa
Join Date: May 2013
Location: Delft
Posts: 607
Rep Power: 0 |
Set your material properties to water and initialize, make sure water is selected under "cell zone conditions", and initialize.
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| bash script for pseudo-parallel usage of reconstructPar | kwardle | OpenFOAM Post-Processing | 41 | August 23, 2023 02:48 |
| big difference between clockTime and executionTime | LM4112 | OpenFOAM Running, Solving & CFD | 21 | February 15, 2019 03:05 |
| 2D bubble rising through a column of water | vof64 | Fluent Multiphase | 0 | August 19, 2014 23:42 |
| Error while starting CFX Pre after meshing | hishtiaq | CFX | 1 | February 1, 2012 10:24 |
| Calculation of a cube (bluff body) | Sepp | FLUENT | 3 | May 15, 2001 08:20 |
Linear Mode
