|
[Sponsors] |
September 4, 2007, 14:22 |
Initialization after Adaption
|
#1 |
Guest
Posts: n/a
|
Hi I need to know that if I need y+ Grid adaption should I have to initilize teh soln again or continue from the last iteration
Thanks |
|
September 4, 2007, 15:30 |
Re: Initialization after Adaption
|
#2 |
Guest
Posts: n/a
|
You can adapt the grid within FLUENT and continue with the same solution. No re-initialization needed. If muoltiple adaptations are needed, you should probably do one at a time, following with some solver interations in between adaptations. Give it a try!
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FMG initialization query | Mohsin | FLUENT | 6 | November 2, 2016 02:02 |
Mesh Adaption in CFX. | Kushagra Mittal | CFX | 1 | August 31, 2011 08:17 |
Unstructured Mesh using Mesh adaption | sidzishere | CFX | 1 | May 31, 2011 10:18 |
compressor initialization | paglia | FLUENT | 0 | February 1, 2006 15:14 |
boundary adaption with geometry based adaption | Kate | FLUENT | 0 | October 9, 2005 10:44 |