|
[Sponsors] |
January 16, 2000, 13:22 |
impinging jet data
|
#1 |
Guest
Posts: n/a
|
Hello everybody out there!
I'm searching for high quality experimental data on impinging heat transfer, preferably with flow measurements as well for CFD validation. Key issues are inlet boundary conditions and geometry: The jet should be confined (by a wall) and channel height(H) through jet width (D) should be about 2 to 8. Axisymmetric jets as well as slot jets will do. Jet Re nr should be between 10000 and 30000. My experience is that jet exit conditions seriously affects calculated heat transfer (especially the turb. lenght scale). Therefore I'm looking for fully developed flow conditions in the jet exit. Regards Andreas ps. If you need a few hints on other exp. setups maybe I can help, I have lots of stuff. Andreas Abdon Division Heat Transfer Lund Institute of Technology Sweden |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Confined Impinging Jet Geometry | furley2372 | Main CFD Forum | 0 | May 31, 2011 20:18 |
How to update polyPatchbs localPoints | liu | OpenFOAM Running, Solving & CFD | 6 | December 30, 2005 17:27 |
impinging jet | natesan | Main CFD Forum | 3 | March 17, 2005 05:42 |
impinging jet | natesan | Siemens | 1 | February 25, 2005 03:16 |
IMPINGING JET ........... HELP!!!!!!!! | Amir Omoumi | Main CFD Forum | 10 | August 30, 1999 22:11 |