BladeGen/ Turbogrid Tip clearance

Prak_32 · January 17, 2018, 07:22

Hi,

I am working on a case to estimate tip clearance effect in a radial turbine.

I have already modeled my blade on bladegen and meshed the same in turbogrid with an acceptable mesh quality.

However, I need to modify the shroud tip clearance to have multiple cases. I have tried doing it in turbogrid by using variable nominal distance at the leading edge and trailing edge. However, this results in trimming of the blade from leading edge and trailing edge. Is there a way by which I can keep my blade dimensions and offset the shroud to achieve different clearance magnitudes?

Any help would be appreciated. Thanks in advance for your suggestions and help.

Regards
Prakhar

DarylMusashi · January 22, 2018, 15:29

Dear Prakhar,

I never used TurboGrid, but in NUMECA's AutoGrid5 its rather easy to

a) change the tip clearance by cutting of the blade
b) modifying the shroud geometry either by drag-and-drop or manually editing the coordinates of the shroud contour (even if the shroud contour is of complex shape).

If you like to know more don't hesitate to contact me.

Kind regards,
Holger

January 17, 2018, 07:22	BladeGen/ Turbogrid Tip clearance	#1
Prak_32 New Member Prakhar Join Date: Dec 2013 Posts: 16 Rep Power: 11	Hi, I am working on a case to estimate tip clearance effect in a radial turbine. I have already modeled my blade on bladegen and meshed the same in turbogrid with an acceptable mesh quality. However, I need to modify the shroud tip clearance to have multiple cases. I have tried doing it in turbogrid by using variable nominal distance at the leading edge and trailing edge. However, this results in trimming of the blade from leading edge and trailing edge. Is there a way by which I can keep my blade dimensions and offset the shroud to achieve different clearance magnitudes? Any help would be appreciated. Thanks in advance for your suggestions and help. Regards Prakhar Last edited by Prak_32; January 17, 2018 at 10:57.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Out File does not show Imbalance in %	Mmaragann	CFX	5	January 20, 2017 10:20
non-constant clearance for BladeGen and TurboGrid?	yuhai	CFX	0	October 31, 2015 05:54
[TGrid] Bladegen w/o turbogrid	Biskvito	ANSYS Meshing & Geometry	5	September 6, 2011 08:13
Tip Clearance	Liam	CFX	3	September 7, 2005 05:30
Tip Clearance	Drona	CFX	0	October 17, 2002 05:25

January 22, 2018, 15:29		#2
DarylMusashi Senior Member Holger Dietrich Join Date: Apr 2011 Location: Germany Posts: 174 Rep Power: 13	Dear Prakhar, I never used TurboGrid, but in NUMECA's AutoGrid5 its rather easy to a) change the tip clearance by cutting of the blade b) modifying the shroud geometry either by drag-and-drop or manually editing the coordinates of the shroud contour (even if the shroud contour is of complex shape). If you like to know more don't hesitate to contact me. Kind regards, Holger