 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] sHM layer reduction towards outlet |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 17, 2016, 05:50
|
sHM layer reduction towards outlet
|
#1 |
|
New Member
Hugo
Join Date: Mar 2012
Location: Frankfurt am Main
Posts: 10
Rep Power: 14  |
Hello Foamers,
I have a question regarding layer insertion in sHM: I have a surface in my model which should be layered (e.g. wall) and an adjacent surface that should have no layer (e.g. an outlet), its 3dimensional, look at the picture below (outlet is at the bottom) sHM is decreasing my layers towards the surface that has no layers - why? I already played with some parameters like nGrow or featureAngle, but with no success. Maybe some of you have a hint. cheers
__________________
Fährste quer, siehste mehr! |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] SHM addLayers doesnt work on the small surface | handicraft | OpenFOAM Meshing & Mesh Conversion | 4 | October 5, 2018 03:50 |
| [snappyHexMesh] Problem airfoil snappyhexmesh add layer | bye bye my blue | OpenFOAM Meshing & Mesh Conversion | 1 | May 5, 2017 05:56 |
| [snappyHexMesh] SHM not snapping to some surfaces | Swift | OpenFOAM Meshing & Mesh Conversion | 13 | January 4, 2016 01:56 |
| [snappyHexMesh] SHM is assigning all faces to the first patch? | me3840 | OpenFOAM Meshing & Mesh Conversion | 2 | September 20, 2015 20:03 |
| [snappyHexMesh] Boundary layer in a pipe | Clementhuon | OpenFOAM Meshing & Mesh Conversion | 6 | March 12, 2012 12:41 |
Threaded Mode
