|
[Sponsors] |
August 31, 2015, 20:53 |
Stubborn epsilonm residual
|
#1 |
New Member
Albert Yiamakis
Join Date: Jun 2015
Posts: 6
Rep Power: 10 |
Hello,
I am running RANS simulations using twoPhaseEulerFoam. While all other residuals decrease with time, that is not the case for epsilonm, which tends to stay constant. This is typical: I noticed that the fluidisedBed tutorial exhibits the same behavior. Is this expected then? Any clues as to why this is happening would be appreciated.
__________________
Home |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
simpleFoam error - "Floating point exception" | mbcx4jc2 | OpenFOAM Running, Solving & CFD | 12 | August 4, 2015 02:20 |
Unstabil Simulation with chtMultiRegionFoam | mbay101 | OpenFOAM Running, Solving & CFD | 13 | December 28, 2013 13:12 |
pimpleFoam: turbulence->correct(); is not executed when using residualControl | hfs | OpenFOAM Running, Solving & CFD | 3 | October 29, 2013 08:35 |
calculation stops after few time steps | sivakumar | OpenFOAM Running, Solving & CFD | 7 | March 17, 2013 06:37 |
Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |