|
[Sponsors] |
September 7, 2013, 08:57 |
About log and | tee log in OpenFOAM
|
#1 |
Senior Member
Mohsen KiaMansouri
Join Date: Jan 2010
Location: CFD Lab
Posts: 118
Rep Power: 16 |
Hi Foamers
I have a question about log and | tee log in OpenFOAM. If I interrupt a run in OpenFOAM for example at t=10sec and then continue it some time later; all the data that was previously been written in the log file (here from t=0 to t=10 sec) will be replaced by this new values (t=10 afterward). So is it possible to use this | tee log in OpenFOAM to write these new data at the end of the previous log file instead of deleting and replacing the old data?
__________________
“If you have an apple and I have an apple and we exchange these apples then you and I will still each have one apple. But if you have an idea and I have an idea and we exchange these ideas, then each of us will have two ideas.” |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Memory protection in OpenFOAM / combinig with FORTRAN | botp | OpenFOAM Programming & Development | 2 | February 15, 2016 12:25 |
Superlinear speedup in OpenFOAM 13 | msrinath80 | OpenFOAM Running, Solving & CFD | 18 | March 3, 2015 05:36 |
[Gmsh] gmsh 2.6.0 conversion to OpenFoam 160 | rosswin | OpenFOAM Meshing & Mesh Conversion | 0 | March 5, 2013 07:34 |
OpenFOAM Debian packaging current status problems and TODOs | oseen | OpenFOAM Installation | 9 | August 26, 2007 13:50 |
OpenFOAM Training and Workshop Zagreb 2628Jan2006 | hjasak | OpenFOAM | 1 | February 2, 2006 21:07 |