|
[Sponsors] |
February 23, 2012, 01:59 |
DirectMapped, ChannelFoam
|
#1 |
New Member
Melika
Join Date: Feb 2012
Location: Japan
Posts: 24
Rep Power: 14 |
Hi everyone
I am simulating the water flow in a pipe using openFOAM 1.6. I use LES, channelFoam and directmapped. When running the case I get the following error: --> FOAM FATAL ERROR: Did not find sample (0.0144554 0.00104187 0.45) on any processor of regionregion0 Does anyone know what the problem is? |
|
February 23, 2012, 02:17 |
|
#2 |
Member
Timo K.
Join Date: Feb 2010
Location: University of Stuttgart
Posts: 66
Rep Power: 16 |
I think it is a bug.
It should be fixed in 1.7 |
|
February 23, 2012, 21:24 |
|
#3 |
New Member
Melika
Join Date: Feb 2012
Location: Japan
Posts: 24
Rep Power: 14 |
Thanks for your comment.
The problem was that I had missed this fact that offset is a vector and the direction of it is from the patch(in my case inlet patch) to the offset plane. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
perturbation in channelFoam? | cheng1988sjtu | OpenFOAM Running, Solving & CFD | 5 | November 2, 2011 15:36 |
channelFoam for a 3D pipe | AlmostSurelyRob | OpenFOAM | 3 | June 24, 2011 13:06 |
new direct mapped programming bc directmapped | Thomas Baumann | OpenFOAM | 9 | June 15, 2011 09:11 |
new directMapped BC for the gradient | David_010 | OpenFOAM | 0 | October 14, 2010 06:29 |
directMapped boundary conditions : pitzDaily3D testcase | And | OpenFOAM | 0 | September 9, 2010 05:11 |