|
[Sponsors] |
March 7, 2002, 14:47 |
Version 3.4 Problem?
|
#1 |
Guest
Posts: n/a
|
It seems to me that with VR-Editor, in version 3.3 I used to copy the following 4 files (after a run terminated) to a new directory and could set that new directory as the working directory and do a restart run from there or run VR-viewer from the new directory. Now it is not so. The 4 files I refer to are myfile.q1, myfile.res, myfile.phi, and myfile.pat. Now I can no longer use VR-viewer nor do a restart run with just these files.
|
|
March 8, 2002, 07:04 |
Re: Version 3.4 Problem?
|
#2 |
Guest
Posts: n/a
|
Patti,
This 'may' be similar to the problem I experienced with saving and hence re-starting runs. The thread starts with 'Don't get a phi file' and you were kind enough to try to help me. For me it was a working directory problem which 'may' also be what is giving you problems. Hope this helps. Mark |
|
March 8, 2002, 11:32 |
Re: Version 3.4 Problem?
|
#3 |
Guest
Posts: n/a
|
Thank you very much, Mark. I tried changing working directory and it gives me an error about "direct access to the phi file" and I tried using the default and user-defined file names (that whole menu is new!) - and I get errors. Eventually VR-Editor just crashed. I will try again and be more careful. I am not sure I like the way the new VR-Editor works (the v3.3 one was more than adequate) - but there may be new parts of it I just haven't used yet. - PattiMichelle
|
|
March 10, 2002, 19:25 |
Re: Version 3.4 Problem?
|
#4 |
Guest
Posts: n/a
|
Well, I tried it again - Without changing the working directory I did this:
I ended a run (End Run) and saved it as a case. Then I saved it again in the same working diretory but as a different case name (so I could do a restart run whilst still saving the original run). VR-Viewer now reports an error (sequential access?? Direct access? What do these mean??) and I can view NIETHER file with VR Viewer now! This sounds like a bug... CHAM may have been trying to extend VR-Viewer somehow - but now I am getting runs I can't read - and I can't do restart runs either: earth won't do it, saying: Error STop - CHeck Data. PattiMichelle |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
New version fluent file open in Old version ? | MANOJKUMAR | FLUENT | 2 | July 10, 2013 04:43 |
Problem when compiling debug version of 141 | kar | OpenFOAM Installation | 0 | February 22, 2008 09:59 |
Difference between Version 6.3 and Version 6.2 | erikaj | FLUENT | 0 | October 11, 2007 12:36 |
Fluent New Version 6.3 Problem Help!!!! | phinix | FLUENT | 1 | March 15, 2007 20:16 |
UDF problem caused by various version of Fluent | Yurong | FLUENT | 3 | January 15, 2006 10:57 |