|
[Sponsors] |
July 11, 2003, 04:57 |
Can this warning influence the results?
|
#1 |
Guest
Posts: n/a
|
when I finished running a model (the boundary in inflow region is a stagnation boundary, the boundary in outflow region are several pressure boundary),I found one warning message at the first some iterations: *** WARNING #061 *** RATIO OF STAGNATION PRESSURE AND STATIC PRESSURE AT REGION 1 CELL *** LESS THEN 1. TEMPORARILY SET TO 1.
And when I checked the solution,I doubted the results are correct,but I was not sure that. So is there anyone who can tell me whether the above warning messages would influence the results? Thanks a lot for your kind help! Lee |
|
July 11, 2003, 06:40 |
Re: Can this warning influence the results?
|
#2 |
Guest
Posts: n/a
|
Since this message only appears at the start of your calculation (which is quite normal as the flow inside tries to adjust), it will definitely NOT affect your results.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gravity (g) Influence on Simulation Results | Colin | FLUENT | 12 | September 23, 2015 09:45 |
Pressure influence | Fanny | Main CFD Forum | 1 | January 30, 2009 23:39 |
influence of yplus | Flo | Main CFD Forum | 5 | July 24, 2008 01:31 |
Influence of Y+ value | xiang | FLUENT | 3 | February 6, 2004 19:31 |
Gravity g's influence on Simulation Results | Colin | Main CFD Forum | 6 | November 2, 2003 14:13 |