|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Jaymes
Join Date: Dec 2019
Posts: 1
Rep Power: 0 ![]() |
Hello all,
I am currently trying to model a randomly packed bed geometry, and am using Star's DEM tools to generate the particles. Everything works just fine until I need to create geometry parts for each sphere. Seen in the picture below, spheres are protruding through my wall surface (even before transforming them into geometry parts), and this is causing me to be unable to mesh correctly later on down the line. [IMG] https://imgur.com/a/EZLj3LB [/IMG] I've gone through the tutorials, plus followed some other videos online, and have yet to find an answer to this problem. My mesh size for the surface is larger than my sphere size, so there shouldn't be a problem between the sphere/wall interaction. Thanks! |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cross section pipe with DEM particles | jeroendemto | STAR-CCM+ | 1 | December 7, 2018 07:29 |
Jet in DEM modeling | huangdf | STAR-CCM+ | 0 | December 7, 2018 00:39 |
Two-Way coupled DEM with heat transfer - Which is good? - disscus now | minhbaba | Main CFD Forum | 0 | November 30, 2018 23:50 |
dsmcFoam - micro-hole limiting the number of dsmc particles | Araist | OpenFOAM Running, Solving & CFD | 0 | June 25, 2015 06:50 |
particles aren't moving with DEM model | czhao86 | FLUENT | 0 | December 4, 2013 14:46 |