|
[Sponsors] |
March 27, 2013, 08:55 |
Prism Layer (Boundary Layer) Thickness
|
#1 |
New Member
Peter
Join Date: Mar 2013
Posts: 1
Rep Power: 0 |
Hi,
i'm using the Star-CCM+ software to model a vehicle and a little confused about the prism layer thickness. I know that the prism layer is to model the boundary layer, but the equation for boundary layer contains the Reynolds number. The Reynolds number changes at each point along the length of the car which will mean that the boundary layer will change. Therefore, what should my prism layer thickness be as prism layer thickness can't change along the length of the car .. Thanks in advance, Peter. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
Prism layer needed to resolve laminar boundary (lowRe) | M10 | STAR-CCM+ | 4 | June 15, 2012 16:21 |
Boundary Layer roughness/ low reynolds wall treatment | Luigi_ | STAR-CCM+ | 1 | March 14, 2012 08:40 |
[snappyHexMesh] Boundary layer generation problems | ivan_cozza | OpenFOAM Meshing & Mesh Conversion | 0 | October 6, 2010 13:47 |
Boundary layer thickness | ghazanfarzahedi | Main CFD Forum | 2 | July 28, 2009 23:43 |