|
[Sponsors] |
November 25, 2013, 10:54 |
Exporting 3D data after analysis
|
#1 |
New Member
Join Date: Sep 2013
Posts: 5
Rep Power: 12 |
Hello friends;
I need your help again. Is it possible to export 3d data after mechanical analysis? In more detail, for example, I use some displacement on a part and after it, part shape chance. In this situation, can I get that chanced 3d geometry in any format? Is it possible? I really really need that information. Thank you for your helps. |
|
February 28, 2014, 06:00 |
|
#2 |
New Member
Florin Gheorghe
Join Date: May 2013
Location: England
Posts: 24
Rep Power: 12 |
Hello friend,
I managed to generate the deformed shape after the structural analysis. All you have to do is after you run the analysis, to plot the deformations; after that go to Geometry, RK>Update Selected Parts>Update Geometry From Results File. Unfortunately there is no way to export this geometry in an external file; this is only used for the mesh update and further use. You can use the deformed finite element model to define a new finite element model, but there is no way to generate new geometry from the deformed finite element model.
__________________
Best regards, Florin |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Exporting data (cell values, ascii) and obtaining more data than cells! | TfG | FLUENT | 3 | April 3, 2015 00:18 |
Error while using profile data in transient analysis | ranjith | CFX | 2 | November 12, 2013 22:52 |
Exporting Data | Tom A | FLUENT | 3 | July 5, 2012 15:54 |
[General] Exporting unstructured, face-based, cell data to VTK | sbaffini | ParaView | 4 | December 18, 2011 15:06 |
Writing profile data at transient heat transfer analysis | Ama | FLUENT | 0 | July 5, 2009 07:35 |