|
[Sponsors] |
May 9, 2013, 01:56 |
Volume Generation Problem
|
#1 |
New Member
Ibrahim
Join Date: Apr 2013
Location: pakistan
Posts: 4
Rep Power: 13 |
There are four attachments with this question
1. Surface Mesh 2. Orfn defined using build topology 3. Boundary Sphere 4. Disoriented volume mesh How to correct this volume mesh? |
|
May 10, 2013, 05:39 |
|
#2 |
Member
jeevan kumar
Join Date: Mar 2009
Posts: 88
Rep Power: 17 |
Did you check the mesh for errors? if there are no errors then the mesher is not able to find a closed body. try to move the material body point inside the domain.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] volume mesh leaking out of the surface, in a multi zone problem | premchandpendota | ANSYS Meshing & Geometry | 6 | July 31, 2012 01:36 |
Negative cell volume problem in-cylinder | ziani.lotfi | FLUENT | 0 | April 11, 2012 07:54 |
[GAMBIT] Gambit - Problem having shadow wall on volume | ejvikings | ANSYS Meshing & Geometry | 3 | March 23, 2012 01:30 |
Ansys 12 Workbench problem when generating volume mesh | Sveink | ANSYS | 5 | January 6, 2010 03:17 |
Star-Design: Volume mesh generation error | fusij | Siemens | 0 | November 6, 2009 12:43 |