|
[Sponsors] |
July 23, 2022, 06:35 |
a wall part inside the fluid domain
|
#1 |
New Member
ENIMA
Join Date: Jul 2021
Posts: 13
Rep Power: 5 |
hi friends,
i'm working on a geometry in ICEM for Cfx Pre flow simulation, the calculation domain is fluid , it has a rectangular form and extruded for 3°. inside the domain the duct of the flow, so i'm struggling with this duct to consider it in the domain as a wall part , i have tried some tips but it doesn't work , the part does not appear in cfx pre i hope that someone can help to fix this problem greetings |
|
July 23, 2022, 08:03 |
|
#2 |
Senior Member
Gert-Jan
Join Date: Oct 2012
Location: Europe
Posts: 1,903
Rep Power: 28 |
Your text is very unclear. I need to read it 5 times to understand it. And without pictuures of your geometry it is even more difficult to understand. Please be more precise next time.
But it looks like you work in ICEM and have a fluid volume with a duct as an obstacle and this duct does not appear in Pre. Does this duct have any volume or is it a sheet (thin surface)? Please show a picture of your geometry......... |
|
July 25, 2022, 12:24 |
answer
|
#3 | |
New Member
ENIMA
Join Date: Jul 2021
Posts: 13
Rep Power: 5 |
Quote:
the duct is a sheet (a thin surface) i have attached a picture of the geometry i hope that every thing is clear thank you for your help |
||
July 25, 2022, 18:13 |
|
#4 |
Senior Member
Gert-Jan
Join Date: Oct 2012
Location: Europe
Posts: 1,903
Rep Power: 28 |
Provided you make a tet/prism-mesh, you should go to Mesh > Part Mesh Setup.
There, on the right hand side, you should tell ICEM that your Geometrical Surface is an Internal wall, or a Split wall. The difference is that the Internal wall will have the same mesh on both sides of the internal wall (conformal), the split mesh will result in different mesh. As a consequence, the Internal wall will give you the option in Pre to define it as a wall or as an interface, i.e. no wall. The split wall can only be used as wall. It has therefore less flexibility, so I would recommend internal wall. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
chtMultiRegionFoam: two fluid regions separated by a thin, conducting wall | JayDeeUU | OpenFOAM Pre-Processing | 16 | July 22, 2021 22:17 |
Table bounds warnings at: END OF TIME STEP | CFXer | CFX | 4 | July 17, 2020 00:44 |
Error - Solar absorber - Solar Thermal Radiation | MichaelK | CFX | 12 | September 1, 2016 06:15 |
How to insert a heat source only in the fluid part of a fluid-air domain? | milabvieira | CFX | 4 | August 21, 2015 08:09 |
[snappyHexMesh] crash sHM | H25E | OpenFOAM Meshing & Mesh Conversion | 11 | November 10, 2014 12:27 |