|
[Sponsors] |
September 20, 2018, 09:22 |
Die design for coextrusion
|
#1 |
New Member
Join Date: Sep 2018
Location: Brindisi
Posts: 1
Rep Power: 0 |
Hello every one,
it is possible to perform a simulation of the inverse prediction for a coextrusion case, to design the die? I'm getting the following error while trying to simulate the inverse coextrsuion process: Dimension fault : no place anymore in the modification list. Value of parameter MAXMOD must be increased (modiftbl.com). We must leave Polydata now. We apologize for the inconvenience. (error code #25 detected) Any idea? Thanks and Regards |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Sensitivity information for custom design variables | dghate | SU2 | 0 | March 20, 2017 06:39 |
Component update can be performed only in base design point | Domenico83 | CFX | 0 | March 10, 2017 05:48 |
JOB: Sr. Thermal/Mechanical Design Engineer | Dee Dee Dial | Main CFD Forum | 0 | April 1, 2003 18:49 |
Info: Short Course On Thermal Design of Electronic Equipment | Arnold Free | Main CFD Forum | 0 | August 10, 1999 10:18 |
CFD - Trends and Perspectives | Jonas Larsson | Main CFD Forum | 16 | August 7, 1998 16:27 |