Home > Forums > Software User Forums > ANSYS > CFX

cfx-mesh

Mark Forums Read

Reply

Search this Thread

October 11, 2004, 04:23	cfx-mesh	#1
jin-wang Guest Posts: n/a	i have a question in meshing. when setting a mesh-control,it seems that the grids` density on the two normal direction of the surface varies at a same rate. can it be controlled into different rate? my English is poor,but i hope you could understand my problem and give me some advices. thank you!

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] SnappyHexMesh for internal Flow	vishwa	OpenFOAM Meshing & Mesh Conversion	24	June 27, 2016 09:54
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation	tommymoose	ANSYS Meshing & Geometry	48	April 15, 2013 05:24
CFX Mesh Deformation problem	Silmaril	CFX	7	October 19, 2010 11:00
Mesh from ICEM CFD to CFX ! Error ! Why ? Thanks !	Vu Trinh Tuan	CFX	11	March 28, 2005 20:04
importing mesh from ICEM CFD into CFX 5	Jay	CFX	2	November 12, 2002 14:46

All times are GMT -4. The time now is 21:32.