|February 13, 2011, 10:22||
Cloud x mesh models
Join Date: Jun 2010
Posts: 50Rep Power: 8
I found in the Lagrangian directory many models which I'm interested in using, such as devolatilisation, surface reaction and evaporation. However, all these models were made based on cloud templates, where the solids are introduced in a compartment through injectors.
My need is to use the devolatilisation, surface reaction and evaporation models on a mesh basis, because my solid region (in fact a porous media) is static and large.
Maybe my description is too short, but I would like to know if there is anyone who already faced this problem, and if yes, what was the solution. If nobody did this before, I would appreciate very much any ideas that could bring some light to this problem.
Thanks in advance.
|February 17, 2011, 18:36||
Join Date: Mar 2009
Location: Lisbon, Portugal
Blog Entries: 39Rep Power: 103
In response to the PM you sent me, I searched for the word "nucleation" here in the forum and picked up on the following threads, which might be useful to you or the users there might know how to do what you need:
As for the cloud templates, I only know that they are used by the solvers in the discreteMethods category in the tutorials.
Best regards and good luck!
|Thread||Thread Starter||Forum||Replies||Last Post|
|vtk mesh or Abaqus mesh to OpenFOAM||bigphil||Open Source Meshers: Gmsh, Netgen, CGNS, ...||27||November 23, 2015 18:31|
|[ICEM] how to mesh a sail (and the rest of the boat)||matteoL||ANSYS Meshing & Geometry||4||May 7, 2012 10:23|
|2D Mesh Generation Tutorial for GMSH||aeroslacker||Open Source Meshers: Gmsh, Netgen, CGNS, ...||12||January 19, 2012 04:52|
|basic of mesh refinement||arya||CFX||4||June 19, 2007 12:21|
|Icemcfd 11: Loss of mesh from surface mesh option?||Joe||CFX||2||March 26, 2007 18:10|