|
[Sponsors] |
|
December 23, 2017, 09:59 |
volumetric shrinkage in ansys
|
#1 |
New Member
Join Date: Nov 2014
Posts: 18
Rep Power: 11 |
Hi
I want to simulate a tooth. it has 2 part. I want to set volumetric shrinkage to one of them and after 20 seconds see the shrinkage and stress in whole bodies. the tooth is isotherm and the temperature is 22 C. so I Can't use thermal module. what do you guys recommend for this physic? I can't find a setting for volumetric shrinkage simulation. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Running Ansys in BAtch Mode | kuleuvenstudent | ANSYS | 1 | October 18, 2017 12:11 |
[ANSYS Meshing] ANSYS mesh - I was surprised... | assafwei | ANSYS Meshing & Geometry | 0 | September 4, 2014 12:17 |
Ansys HPC licensing policy | assafwei | ANSYS | 0 | June 29, 2014 16:00 |
Using ICEM CFD to repair/edit ANSYS Meshing | Kaaji1359 | ANSYS | 2 | July 30, 2013 10:28 |
Exporting results from CFX to ANSYS ?? | sohail ahmed | CFX | 1 | December 20, 2007 01:10 |