better tecplot output?

jentink · November 8, 2018, 18:49

Trying to output a tecplot solution. There's no way to separate out the boundary surfaces. ie, wall, inflow, outflow are not zones in my tecplot file. Is there a direct cgns output option?

hlk · November 16, 2018, 22:39

Please take a look at the surface_flow.dat output file, to see if that works for you - this will contain the information on the boundaries specified by the MARKER_PLOTTING option.

An ad-hoc solution to have the boundaries in separate zones would be to repeatedly run SU2_SOL with config files that have different values in MARKER_PLOTTING and SURFACE_FLOW_FILENAME, making sure to also specify the correct solution files. Those files could then be loaded to a single tecplot layout.

November 8, 2018, 18:49	better tecplot output?	#1
jentink Member Tom Jentink Join Date: Jan 2013 Posts: 61 Rep Power: 14	Trying to output a tecplot solution. There's no way to separate out the boundary surfaces. ie, wall, inflow, outflow are not zones in my tecplot file. Is there a direct cgns output option?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[swak4Foam] outputTime in Swak function	immortality	OpenFOAM Community Contributions	20	October 6, 2022 13:08
Su2 V5.0.0 developer branch sliding interface feature: Tecplot output file problem	JyothiKumar	SU2	1	August 11, 2017 10:23
writing execFlowFunctionObjects	immortality	OpenFOAM Post-Processing	30	September 15, 2013 07:16
Tecplot output format in 2-D cartesian grid	jinwon park	Tecplot	5	April 7, 2008 07:28
Output data from STAR-CD to Tecplot	Lee	Siemens	0	June 5, 2006 13:58

November 16, 2018, 22:39		#2
hlk Senior Member Heather Kline Join Date: Jun 2013 Posts: 309 Rep Power: 15	Please take a look at the surface_flow.dat output file, to see if that works for you - this will contain the information on the boundaries specified by the MARKER_PLOTTING option. An ad-hoc solution to have the boundaries in separate zones would be to repeatedly run SU2_SOL with config files that have different values in MARKER_PLOTTING and SURFACE_FLOW_FILENAME, making sure to also specify the correct solution files. Those files could then be loaded to a single tecplot layout.