 |
 |
 |
|
|
|
[Sponsors] | ||||
May 28, 2018, 19:15
|
drawing streamtraces(surface line) in slices
|
#1 |
|
New Member
pouya
Join Date: Jun 2017
Posts: 11
Rep Power: 8  |
Hi friends
I'm drawing streamtraces in slices for hydraulic channel , but I can not use surface line and nothing is shown!!!!! It only shows the volume line(drawing lines are very irregular  )What can I do to show the surface line  ?best regards pouya ahmadi |
|
|
|
|
|
May 29, 2018, 12:46
|
|
#2 |
|
Member
Join Date: May 2013
Posts: 61
Rep Power: 13 |
At this time you cannot place surface streamtraces on a slice. The same effect can be achieved by extracting the slice then seeding surface streamtraces on the extracted zone.
|
|
|
|
|
|
|
May 30, 2018, 20:28
|
|
#3 |
|
New Member
pouya
Join Date: Jun 2017
Posts: 11
Rep Power: 8 |
solved!!!
thank you 
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Other] refineWallLayer Error | Yuby | OpenFOAM Meshing & Mesh Conversion | 2 | November 11, 2021 11:04 |
| problem during mpi in server: expected Scalar, found on line 0 the word 'nan' | muth | OpenFOAM Running, Solving & CFD | 3 | August 27, 2018 04:18 |
| [blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
| Installation OF1.5-dev | ttdtud | OpenFOAM Installation | 46 | May 5, 2009 02:32 |
| Problems of Duns Codes! | Martin J | Main CFD Forum | 8 | August 14, 2003 23:19 |
1Likes
Linear Mode
