OpenFOAM

Rating Thread / Thread Starter	Last Post	Replies	Views
Sticky: Wiki ( 1 2 3 ... Last Page) gschaider	December 31, 2014 07:34 by wyldckat	178	67,533
Sticky: Getting Started with OpenFOAM ( 1 2) wyldckat	August 14, 2022 13:55 by mikethe1wheelnut	25	50,766
Sticky: OpenFOAM.com versus OpenFOAM.org: Which version to use? wyldckat	March 25, 2023 07:50 by ancolli	19	59,488
Sticky: How to contribute to the community of OpenFOAM users and to the OpenFOAM technology wyldckat	November 10, 2017 15:54 by rdbisme	17	20,535
Sticky: Map of the OpenFOAM Forum - Understanding where to post your questions! wyldckat	September 2, 2021 05:29 by hakosaj	10	21,769
Sticky: How to give enough info to get help linnemann	September 20, 2017 09:19 by linnemann	8	55,336
why different models lead to different result for a same low-Re RAS case? Sunxing	December 10, 2012 02:59 by Sunxing	0	1,004
output the U_0 and p_0 hz283	December 8, 2012 09:56 by hz283	0	1,435
About cyclic boundary condition mmkr825	December 14, 2012 01:36 by mmkr825	0	1,234
Lagrangian droplet mass projection in OpenFoam?????? MMK	December 11, 2012 13:13 by MMK	0	1,422
About cyclic boundary condition mmkr825	December 16, 2012 23:44 by mmkr825	0	1,313
Flow simulation with mesh help MarkoB	December 18, 2012 16:13 by MarkoB	0	941
Boundary conditions zaynah04	December 24, 2012 03:08 by zaynah04	0	1,270
interTrackFoam and bubbleInterTRackFoam problems hfsf	December 26, 2012 02:12 by hfsf	0	1,313
Adaptive fixedValue/zeroGradient vwibaut	January 28, 2013 11:17 by vwibaut	0	1,099
Maxwellslip boundary condition in openfoam masood135	January 26, 2013 15:53 by masood135	0	1,071
properties of solid mixture Ahmed Khattab	December 26, 2012 13:59 by Ahmed Khattab	0	1,710
calculation of laminar dynamic viscosity in BasicThermo.H hz283	December 28, 2012 12:06 by hz283	0	1,257
foam mesh to fluent zaynah04	January 2, 2013 09:05 by zaynah04	0	1,433
Maximum Iterations Exceeded while using rhoPorousMRFSimpleFoam prasant	January 5, 2013 03:12 by prasant	0	1,044
How to set a right initial conditions for a wall-jet flow case using rhoPimpleFoam Sunxing	January 5, 2013 04:02 by Sunxing	0	990
reisiduals in simplefoam hawkeye321	January 8, 2013 16:25 by hawkeye321	0	1,052
How to simulate an aerator danvica	January 14, 2013 16:02 by danvica	0	1,340
cyclicAMI interface burt	January 14, 2013 22:13 by burt	0	1,212
definition of p-norm for a field codinging	January 15, 2013 12:59 by codinging	0	1,428
Prescribe time for collecting signal in LES using Probes?? deji	January 15, 2013 16:00 by deji	0	994
Radiation boundary condition ahmmedshakil	February 7, 2013 01:05 by ahmmedshakil	0	1,257
Temperature discontinuity at interface - laplacianFoam Shriya	February 4, 2013 06:44 by Shriya	0	1,459
Extract the 3D mesh size from openfoam or paraview hz283	February 7, 2013 07:19 by hz283	0	2,029
Tutorial for 3D engine simulation sasanghomi	February 7, 2013 07:40 by sasanghomi	0	1,576
pointProcAddressing and faceProcAddressing ganeshv	February 14, 2013 14:43 by ganeshv	0	1,926
Source in boundary due to moving wall hrushi.397	February 11, 2013 04:59 by hrushi.397	0	995
FFT of Cl with non-constant time step Antonio.vucci	February 12, 2013 14:43 by Antonio.vucci	0	1,172
cavity length on disk, amin.rahimi64	February 11, 2013 08:34 by amin.rahimi64	0	978
cantera 2.0.1 and OpenFOAM-1.7.1 adhiraj	February 11, 2013 13:17 by adhiraj	0	1,552
Eddy turnover time calculations anishtain4	February 12, 2013 04:27 by anishtain4	0	1,963
Revolving a wedge geometry/data sagnikmazumdar	February 12, 2013 15:10 by sagnikmazumdar	0	1,014
How to start: modeling tufts in airflow Wedge Antilles	February 13, 2013 12:56 by Wedge Antilles	0	1,018
Timisoara Swirl Generator aanton	February 13, 2013 13:37 by aanton	0	1,667
very large value of time continuation error for simpleFoam jr33	February 14, 2013 23:10 by jr33	0	893
Help in deformable mesh (interDyMFoam) hfsf	February 15, 2013 09:53 by hfsf	0	1,568
Sutherland property hg2lf	February 19, 2013 06:51 by hg2lf	0	1,273
Temperature dependent propertys and finalIteration in chtMultiRegionFoam waiter120	February 20, 2013 05:22 by waiter120	0	1,580
gradSchems specification lichmaster	February 20, 2013 10:25 by lichmaster	0	1,053
field phi in icoFoam hawkeye321	February 20, 2013 17:07 by hawkeye321	0	1,148
Derivation of pdEquation deji	February 20, 2013 18:19 by deji	0	1,027

Read this first: How to ask a question on the forums

Page 199 of 239

199

	New posts		Hot thread with new posts
	No new posts		Hot thread with no new posts
	Thread is closed

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

All times are GMT -4. The time now is 23:55.