OpenFOAM

Rating Thread / Thread Starter	Last Post	Replies	Views
Sticky: Getting Started with OpenFOAM ( 1 2) wyldckat	June 21, 2024 06:54 by Martin_Sz	26	51,545
Sticky: OpenFOAM.com versus OpenFOAM.org: Which version to use? wyldckat	March 25, 2023 07:50 by ancolli	19	60,863
Sticky: Map of the OpenFOAM Forum - Understanding where to post your questions! wyldckat	September 2, 2021 05:29 by hakosaj	10	21,899
Sticky: How to contribute to the community of OpenFOAM users and to the OpenFOAM technology wyldckat	November 10, 2017 15:54 by rdbisme	17	20,726
Sticky: How to give enough info to get help linnemann	September 20, 2017 09:19 by linnemann	8	55,941
Sticky: Wiki ( 1 2 3 ... Last Page) gschaider	December 31, 2014 07:34 by wyldckat	178	68,015
masterthesis Water/Air spray tharkus	April 16, 2014 01:38 by amkokko	4	3,229
I dont know if its suitable to post this: who are there bug fixer? sharonyue	April 15, 2014 21:47 by sharonyue	4	1,460
surface sampling with a step smaller than outputTime seiji_adachi	April 15, 2014 04:44 by adarsh tiwari	3	1,580
Multicomponent fluid diffusion houwy	April 14, 2014 08:37 by houwy	0	1,216
Change of boundary conditions during run time Alexsakowitz	April 12, 2014 01:23 by lavdwall	5	7,237
Error with reactingFoam pankajdg	April 11, 2014 15:02 by vinz	1	1,634
Foam::error::printStack(Foam::Ostream&) at ??:? Dream	April 11, 2014 01:48 by zhan	1	1,809
Could not determine array range tjliang	April 10, 2014 13:44 by nimasam	1	4,309
Solution is NOT APPROPRIATE WHEN COMPARED TO CFX adarsh tiwari	April 10, 2014 02:25 by adarsh tiwari	4	1,377
Unknown patchField type compressible::alphatWallFunction for patch type wall dante03	April 10, 2014 01:15 by hamed_m313	1	4,026
Help with OpenFoam Eli_Brazil	April 9, 2014 09:00 by blacksquirrel	4	1,821
Courant number libra	April 9, 2014 07:40 by Bernhard	8	3,301
Counterflow Turbulent diffusion Flame ssrivas3	April 8, 2014 17:02 by ssrivas3	2	2,070
coupling two solver???? mehran68	April 8, 2014 11:04 by nimasam	1	1,109
Rotating rotor inside a frame ( 1 2) wllmk1	April 8, 2014 06:58 by sam.ho	38	8,878
release a passive scalar from within the computational domain & toposet Barry	April 7, 2014 14:23 by tian	1	1,765
Unable to run tutorial "basic/laplacianFoam/flange" madhur123	April 6, 2014 14:49 by wyldckat	1	3,414
Heat transfer problem guido.bonalumi	April 5, 2014 10:09 by guido.bonalumi	0	954
How feasible/convenient is it to model this furnace in OpenFoam ? ankur_kr	April 4, 2014 15:36 by ankur_kr	2	2,038
time step directories naming issue Andrea_85	April 3, 2014 08:38 by alexeym	3	3,588
fluid-structure interaction with twophase fluid bieshuxuhe	April 2, 2014 23:02 by bieshuxuhe	0	1,483
how to simulate temperature field on flat plate with heating source and convection madhur123	April 1, 2014 07:14 by bieshuxuhe	1	1,205
Tank & Mixer monty86	April 1, 2014 05:42 by monty86	0	1,589
interfoam: a problem with removing convection in the air phase bieshuxuhe	March 31, 2014 22:56 by bieshuxuhe	0	1,644
Problems of bad results with LES Sunxing	March 31, 2014 05:11 by vut	10	2,039
interfoam:a problem with Air-phase convective-term treatment bieshuxuhe	March 31, 2014 02:52 by bieshuxuhe	2	1,534
Divergence only by lengthening of simulated geometry, buoyantPimpleFoam arvhult	March 29, 2014 17:03 by nsf	16	2,709
solidParticleFoam - segmentation fault mikeP	March 28, 2014 07:13 by houwy	2	1,767
Where is 'transportProperties' in the solver 'twoPhaseEulerFoam' 2.3.0? mxylondon	March 28, 2014 03:30 by mxylondon	2	1,383
Bc.S project, Heat Transfer Sumoboy	March 27, 2014 08:54 by Sumoboy	0	1,110
solver for CFD analysis of heat reduction of water in cooling tower using Openfoam? 13msmemusman	March 26, 2014 12:39 by 13msmemusman	0	1,705
Problem with INTERPHASECHANGEFOAM shipman	March 26, 2014 12:36 by vut	2	2,046
Particle size change houwy	March 26, 2014 03:47 by houwy	0	1,145
Gambit Axisymmetric Neutral File Problem SandyS	March 25, 2014 07:08 by palmerlee	4	3,762
Solver for Laminar incompressible transient flow RTom	March 24, 2014 22:51 by RTom	4	2,048
Different fluids, question lenzo	March 24, 2014 16:55 by zhengzh5	4	1,244
Poll: How to add a time dependent source term to icoFoam? kirikù	March 23, 2014 20:24 by wchen	2	2,754
Pressure Outlet boundary condition in OpenFOAM dipsar	March 23, 2014 09:59 by dipsar	0	1,927
Sensible Enthalpy brbbhatti	March 21, 2014 09:08 by dkxls	3	4,104
Evaporation Model brbbhatti	March 21, 2014 04:50 by brbbhatti	3	2,713

Read this first: How to ask a question on the forums

Page 101 of 240

101

	New posts		Hot thread with new posts
	No new posts		Hot thread with no new posts
	Thread is closed

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

All times are GMT -4. The time now is 22:09.